日本思达CEDAR 代理 优势供应
|Measurement range||0.030～4.000 N・m||1.5～200.0 mN・m||0.30～15.00 N・m|
(500 or less digit±5digit)
|±0.5% (200 or less digit±1digit)|
|Display||The 4 figures digital display of LCD|
The measurement direction
|CW-CCW (right and left)
A display will be the display of only an absolute value.
Load of + (the CW direction) and – (the direction of CCW) is carried out to a data output.
Measure- ment Mode
|The peak value of load is held. Destructive torque (the CW direction) — it loosens and torque (the direction of CCW) is measured.|
|TR(truck)||A display changes with load change.|
|The judgment of slip torque and the judgment of the yield point are performed. (Only the CW direction)|
|Detection judging||If a slip torque value is detected, you will be told about by green lamp lighting. (at the time of PD mode)|
|Measurement start value setup||The value which starts measurement (start of judgment operation) is set up. ( 0.001 N-m unit from 0 N-m)|
Continuation data output
|A load torque value is outputted for every fixed time during measurement in PP＆PD mode.
By creating a torque wave, loci, such a slip torque, yield point torque, and destructive torque
can be judged.
|Auto-power-off||After the neglect during 10 minutes, Power source OFF|
|Bit plug form||HEX 6.35||φ4||6.35sq|
|Data output||ASCII format (baud rate 9600)|
|Detector||About 820g||About 80ｇ||About 1.4kｇ|
Accessories (one piece each)
|Bit ＋○ #1 #2||Bit ＋○ #0|
|An inspection report, a proofreading certificate, a traceability system figure|